Instructions - Copper Metal Art Waterfall Weavings
Decide on sizes
Valence needs to be cut +2” wide and +1.25” high
Fold over the edges ¼” all the way around – hammer down flat on 3 sides
Keep an open lip on the side to which the strips will be attached
Then fold up the sides ¾” on three sides
Remember to trim off the sides and tabs to allow proper folding
Strips need to be cut ½” long, since the tops get folded over ¼ and the valence hides ¼”
Interwoven wires
Mark the back side of the strips every 2”
Cut the wires longer than necessary
Hammer them as flat and straight as possible
Weave them in – solder in place
Pole backing
Braze or solder corners
Copper pole at top
Copper pole on top of strips
Wash and dry
Lacquer the back too
if this is useful to you or you like what you read, why not give me a link on your site?